News
System is equipped with advanced 8-axis motion controller for stepper and servo motors (DeltaTau Turbo PMAC), provides full support for absolute position feedback, integrates HW protection for axis end limits (via custom module) and allows detection of maximum allowed inclination of controlled equipment (tilt switch). M-Box motion controller solution is fully supported in the EPICS control system.
Together with full control system support is currently in the phase of factory acceptance test at Danfysik.
microIOC M-Box was especially designed with the following benefits in mind:
More informations about M-Box product can be found on microIOC product page:
http://www.microioc.com/M-Box.htm
21.11.2006
New product from Cosylab - M-Box
microIOC M-Box motion controller is an example of latest full-featured microIOC customization. It was customized to meet specific requirements of DanfysikSystem is equipped with advanced 8-axis motion controller for stepper and servo motors (DeltaTau Turbo PMAC), provides full support for absolute position feedback, integrates HW protection for axis end limits (via custom module) and allows detection of maximum allowed inclination of controlled equipment (tilt switch). M-Box motion controller solution is fully supported in the EPICS control system.
Together with full control system support is currently in the phase of factory acceptance test at Danfysik.
microIOC M-Box was especially designed with the following benefits in mind:
- all-in-one solution for advanced control of up to 8 axis (absolute position and
inclination feedback) - complete integration into the control system
- HW protection for absolute-end positions
- direct/customized connection of all equipment
More informations about M-Box product can be found on microIOC product page:
http://www.microioc.com/M-Box.htm
microIOC is manufactured by Cosylab
